On a Les Paul, SG and similar guitars, string pressure holds the bridge and tailpiece in position. Keeping some strings on the guitar keeps everything where it was set.
Steps:
- Detune and remove one string, pulling the ball end out through the tailpiece.
- Thread the new string into the back of the tailpiece and through toward the neck until the ball end seats.
- Lay the string over the correct saddle groove on the bridge.
- Bring it to the tuner, leave enough slack for a few wraps, and wind downward.
- Tune close to pitch, then move to the next string.
- Settle the strings and retune.
If you do remove all the strings, for cleaning, note which way the bridge faces first. Many tune-o-matic style bridges are installed with the saddle screws facing the pickups or the tailpiece, and putting it back reversed changes intonation. A strip of low-tack tape across the bridge keeps it from lifting off.
Check that each string sits in its saddle groove and doesn't touch the edge of the bridge or tailpiece. Our S1046 and S1150 in Power Wound Nickel, or PN1046 in Power Groove Pure Nickel for a warmer voice, suit this kind of guitar.
